01-25-2017, 12:57 PM
Could they drill a hole horizontally and then ream it to the final size? I know they use methods like that for sinking shafts, but I don't know if it would work for horizontal shafts.
Welcome Guest!
In order to take advantage of all the great features that Waterloo Region Connected has to offer, including participating in the lively discussions below, you're going to have to register. The good news is that it'll take less than a minute and you can get started enjoying Waterloo Region's best online community right away.
Login or Create an Account
In order to take advantage of all the great features that Waterloo Region Connected has to offer, including participating in the lively discussions below, you're going to have to register. The good news is that it'll take less than a minute and you can get started enjoying Waterloo Region's best online community right away.
Login or Create an Account
Waterloo Region Connected
/
Waterloo Region Works
/
Transportation and Infrastructure
/
Highway 7 - Kitchener to Guelph
/
Highway 7 - Kitchener to Guelph
Thread Rating:
|
Highway 7 - Kitchener to Guelph
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 26 Guest(s)